If we do not have the full amount that you ordered of this item:
Add to Cart
Templates for thirteen different heraldic symbols are included: crown, medieval cross, castle, shield, dragon, leaf, crescent moon, cinqfoil, bee, bird, fleur de lis, axe, and arrow. These can be used as appliques or the designs can be applied using fabric paint.The rump cover will fit horses with blanket sizes of roughly 60 to 84. The chest piece comes in one size only and will need to be reduced in size for smaller horses and ponies.
The rump cover is worn over a regular saddle pad, so it should be long enough to cover the front of the pad and extend to the end of the horse's hindquarters. Though some are deep enough to reach the ground, we recommend that it should be no longer than the horse's knees or hocks to prevent the horse's legs from getting tangled. Otherwise it can be any length from just covering the horse's belly to reaching the knees and hocks. The finished length of the unaltered rump cover, from topline to hem, is 50".
The chest piece is tied to the D-rings on the saddle. It will fit average and larger horses. The size is adjusted by shortening or lengthening the ends and then by tying the ends to the D-rings.
If you are making this for a small horse or a very large horse, you might have to redraw the pattern pieces to get the size you need.
The rein coverings should be long enough to cover the reins when they are held so that there is a straight line from the bit to the rider's hands as shown. It is better to make them too short, because you don't want them interfering if you have to suddenly take a very strong hold on the reins. Any part of the reins held by the rider should NOT be covered. The finished length of the unaltered rein cover is 24".FABRICS
The large sections of the rump cover and the chest piece are made from one color- Color 1 in the instructions. The trim on the edges is made using a different color- Color 2 in the instructions.YARDAGES - 60" WIDE FABRIC REQUIRED